20 MHz Oscilloscope (511) In Stock Now

VERTICAL AMPLIFIERS (CH 1 and CH 2)

• Sensitivity: 5mV/div to 5V/div, 1mV/div to 1V/div at X5
• Attenuator: 10 steps in 1-2-5 sequence. Vernier control provides full adjustment between steps
• Accuracy: ±3%, ±5% at X5
• Input Resistance: 1 MΩ ±2%
• Input Capacitance: 25 pF ±10pF
• Frequency Response: 5mV to 5V/div: DC to 30 MHz (-3dB). X5: DC to 10 MHz (-3dB)
• Rise Time: 12 ns (Overshoot ≤5%)

Operating Modes:

• CH 1: CH 1, single trace
• CH 2: CH 2, single trace
• ALT dual trace, alternating
• CHOP dual trace, chopped
• ADD agebraic sum of CH 1 + CH 2
• Polarity Reversal CH 2 only
• Maximum Input Voltage: 400 V (DC + AC peak)

SWEEP SYSTEM

• Sweep Speed: 0.1 μs/div to 2 s/div in 1-2-5 sequence, 23 steps,
• Vernier control provides fully adjustable sweep time between steps.
• Accuracy: ±3%
• Sweep Magnification: 10x

TRIGGERING

• Triggering Modes: AUTO (free run) or NORM, TV-V, TV-H
• Trigger Source: CH 1, CH 2, ALT, EXT, LINE
• Maximum External Trigger Voltage: 300 V (DC + AC peak)
• Trigger Coupling: AC 30 Hz to 30 MHz
• TV H: Used for triggering from horizontal sync pulses
• TV V: Used for triggering from vertical sync pulses

TRIGGER SENSITIVITY

• Auto Bandwidth: 100 Hz-30 MHz, Internal: 1.5 div, External: 100 mV
• Norm Bandwidth: DC to 30 MHz, Internal: 1.5 div, External: 100 mV
• TV V Bandwidth: 20 Hz-1 kHz, Internal: .5 div, External: 100 mV
• TV H Bandwidth: 1 kHz-100 kHz, Internal: .5 div, External: 100 mV

HORIZONTAL AMPLIFIER (Input through channel 2 input)

• X-Y Mode Switch selectable using X-Y switch. CH 1: X axis, CH 2: Y axis
• Sensitivity: Same as vertical channel 1
• Input Impedance: Same as vertical channel 1
• Frequency Response: DC to 1 MHz typical (-3 dB)
• X-Y Phase Difference: Approximately 3 ̊ at 50 kHz
• Maximum Input Voltage: Same as vertical channel 1

CRT

• Calibrating Voltage: 1 kHz (±10%) Positive Square Wave, 2 V p-p (±3%)